We finish all installation and testing of Vacuum Transformer Oil Purifier, users can operate it directly when they receive the machine. This article mainly introduces the installation of Transformer Oil Purifier. In order to bear the weight of the entire vacuum oil purifier, the installation of vacuum oil purifier usually has two bearings with skids at the head and tail.

The tail end of the vacuum Transformer Oil Purifier (thrust plate end) is connected to the supply pipe, and the support Vacuum Oil Purifier end of the tail end is bolted to the base. The head of the Transformer Oil Purification Machine (the end of the press device) is located away from the tail, and the two beams are connected by two beams. The beam length of the large vacuum oil purifier is about 10-20 meters, and there are two support legs in the center of each side beam. During filtration, the beam is affected by the pressure of the pressurized device (horizontal) and the slurry load (vertical). In the horizontal direction, the pressure transmitted by the hydraulic cylinder and piston rod causes the elastic extension of the beam. The elongation of the Vacuum Oil Purifier can reach 5mm, so the end of the press should be able to stretch freely. Therefore, during the installation of Transformer Oil Purification Machine, it is necessary to float and install two support legs and two side beams at the bottom of the compression end, and they are not connected with the support base. The compressor brackets are floating, but the filter brackets have three prefabricated retention rods and two side retention rods at the bottom of each bracket, but the front holding rod limits the elasticity of the beam. The elongation must be removed. During the process, due to the limitation of the front holding iron, the cross beam of Vacuum Oil Purifier is deformed in the horizontal direction, and the support roller at the pressing end is separated from the beam.

The Transformer Oil Purification Machine is equipped with PLC-controller, touch screen, foam eliminator, auto drain pump, pre-filter, find filter, vacuum chamber, vacuum pump, roots pump, feed and discharge pump, heater, pneumatic nozzle, etc. In actual operation, when each component deteriorates, it is difficult for the vacuum oil purifier to ensure the automatic cleaning of the prefilter. Remove and cleaner the filters one by one when pressure gauges of filters reach 0.3 mPa. When the oil content of the treated slurry is high, it indicates that the oil film attached to the surface of the filter can be cleaned.

For some simple filter press type Transformer Oil Purification Machine, it is different to vacuum oil purifier. During the unloading process, the filter cake often falls on the guide rail of the entire plate, which destroys and deteriorates the lubrication state of the entire plate mechanism binding machine. After one year of operation of the transformer oil purifier, open the chain covers on both sides to wash the accumulated mud, and at the same time remove the chain, immerse in oil, and clean the kerosene. Through the continuous operation of the transformer oil purification machine, the distance between the finger of the entire plate mechanism and the lugs of the filter plate gradually increases, so that the entire plate institution has an irregular silver plate financial binding machine, and the entire plate mechanism must be replaced in time.