+86 132 06063693

sales@acorefiltration.comsales@acorefiltration.com
Lube Oil Purifier
Lubricating Oil Purifier to Reduce Pollution November 8,2019.

VLF Lubricating Oil Purifier is used to remove solid impurities and water, which can reduce the pollution of the lubricating oils, such as gear oil, hydraulic oil, turbine oil, etc. The Lubricating Oil Purifier specially for filtering fine solid impurities, especially common oil filtration machine can not the purify ordinary high viscosity liquid. It is a replacement for a plate and frame pressure type oil filtration machine. For the case where the mechanical impurities have just been removed out, the machine is more convenient than the vacuum oil purifier, the cost is low, the precision is higher than that of the ordinary oil filtration machine, the working life is longer and more flexible, and the constant temperature heating can reduce the consistency without changing. High filtration accuracy and stability. Therefore, lubricating oil is widely used in electric power, manufacturing, automotive, railway, metallurgy, steel rolling, mining, etc. The oil has a lubricating function, filtration rather than flammable and non-lubricating liquids.


When the Oil Filtration Machine works, the oil contaminated the surrounding atmosphere enters the heater through the vacuum suction of the inlet, the heating oil enters the pre-filter, the large particle impurities are filtered out, then the oil is poured into the trap, the vacuum is separated, and the divergent flow is passed through a special s method. The diverging device oil produces a large surface area per unit volume, which causes the oil to be exposed to low relative humidity in the atmosphere, thereby removing oil in water, air and gas. The evaporation of water vapor, the mixed gas of the gas box formed by the cooler, is condensed into a liquid, and is stored together, and the residual gas is a vacuum pump passage. Water is removed by the drain pump input filter to remove fine particulate impurities, i.e., oil purifier to complete, depending on how much water content, to complete the number of cycles required to completely remove moisture.


1. The components of the Oil Purifier are factory tested and transferred to the site of use to check that all components are intact.


2. The oil filtration machine is placed in a stable oil inlet and turned down to the reservoir drain port, and the port is opened to the top of the tank.


3. Connect the power supply and the grounded Oil Purifier. Distribution cabinets and pumps, vacuum pumps, heater wires in the machine should be checked to ensure safe and reliable insulation.


4. The oil pump motor is started again to see if it is in the clockwise direction (from the front end of the motor). Otherwise, the power exchange phase.

5, when the hydraulic oil and other petroleum processing machinery online operation, the appropriate level of oil should be properly supplemented to ensure a normal fuel tank.


Previous Post Next Post

Copyright © 2024 Acore Filtration Co. Ltd.

Request A Quote

Request A Quote